Different cars and shifters may have specific installation steps 0:00 intro 0:08 kartboy short throw shifter and torque solutions pivot bushings 0:18 tools needed 0:26 jack up the car 0:31 trim removal 1:06. Covers compatibility, torque specs, and common pitfalls.
Dodge RAM SRT10 (2004-06) Performance Short Throw Shifter Stick Kit
Insert the shifter rail pin into the bd short shifter arm and then insert the roll pin with a small hammer
Be careful not to round the end of the roll pin or the shifter rail pin will not be properly secure.
Now get ready to install the new short throw shifter Remove the old plastic bushing and the old gasket Insert the shifter into the plastic bushing Bolt on the shifter handle
Easiest way to remove shift knob is to pull up with force while twisting back and forth a little bit Sometimes it's too ahrd to just pull straight up Just wiggle it while pulling and it should come. I am positive there is a youtube video on it
Disconnect battery remove starter remove shifter boot remove shifter place floor jack under tail of transmission remove transmission cross member.
Each guide provides clear instructions to ensure perfect fitment. In this article, we will walk you through the common steps and tools needed for most installs together with some tips and tricks Lift up on the rear portion of the shift control closeout boot retaining ring and detach the retaining ring from the. I have seen some dakotas with the shifters in the floor (aftermarket) i was wondering how hard it was to get the shifters there and if you can do it your self
It seems all you need to do is run the. All that so we can shift through each gear faster
