To adjust the drag link, first, locate the adjusting sleeve on the link and loosen the lock nuts Used some angle iron and a tape. When i tightened the drag link caps, i was using a screwdriver
Steering wheel alignment | Drag Link Adjustment - YouTube
I know the manual says to tighten the caps until the springs are compressed fully and then back off to.
Once the steering wheel is straight, tighten the jam nuts on the drag link and torque to 200 ft/lbs
Remove your oem drag link assembly Of grease to the top of the boot This will create a lubricated. It’s currently on my lift getting an oil change and grease now, replacing the grease fitting.
As of february 2023, both the bottom mount drag link and the tie rod ends for the jl and jt linkages. It will be necessary to adjust the new drag link to allow for attachment to the pitman arm and steering arm Adjustments should be made equally on both ends of the drag link As for adjusting the drag link, key on, engine off, tires straight and adjust the drag link adjustment sleeve until the wheel is straight
If done properly, steering isn't effected.
A drag link is a rigid metal rod in steering systems that transfers force from the steering gear to the wheel's steering knuckle. Joe also demonstrates how to cut and tap a drag link for rod ends if you need to cut down your drag link or tie rod to fit your build Separate the steering stabilizer stud from the factory drag link by using a tie rod separator tool or by striking the drag link near the taper with a large hammer. Wheels off the ground, on the ground
Which way to turn the drag link collar, pull down or push. I followed the precise instructions available on the 4crawler.com site
