Install the new crush sleeve (if applicable) or shims, followed by the outer pinion bearing, washer, and a new pinion nut Tips and tricks to set up a pinon on a crush sleeve. Gradually tighten the pinion nut while continuously.
Motive Gear Differential Crush Sleeve 3115
Anyone here pulled a crush sleeve and replaced with a solid spacer on the rear diff
My rear axle was rebuilt a few years ago with a trutrac and i want to get a 1350 pinion yoke and solid sleeve.
After pulling the outer bearing down with the yoke, i performed a trick regarding crush sleeves Apply a layer of grease on. When installing a new crush sleeve, tighten the pinion nut gradually to achieve correct preload Use a torque wrench to apply specified torque, then rotate the pinion to seat the sleeve properly.
If it's an offroader and you beat on it hard, deleting the crush sleeve and using a solid spacer is the way to go You set your pinion depth with shims like normal, but with a solid spacer you. In theory, it seems to me that over time or with heavy. How to install ring and pinion gears
This video shows how the pinion is installed
If you want to see my full install videos from start to finish, check out my playlist found here The crush collar or sleeve is a part common to the vast majority of production rear (and front) differentials The manufacturers use them to expedite the assembly process, but under even normal. A differential crush sleeve eliminator kit is a set of components designed to replace the crush sleeve in a differential assembly
The crush sleeve is a thin metal sleeve that is used to set the proper preload on. The crush sleeve aides in rapid assembly at the factory and is a one time use item Use the solid spacer and enjoy the luxury of replacing the pinion seal down the road if necessary without. It may not be obvious, but the crush sleeve eliminator for the ford 8.8 inch axle is directional
If you install it wrong it will mess up the spacer, and won't seat correctly either.
A crush sleeve is an easy way for mfg to save time assembling the rear end Put in a crush sleeve and torque to a value The spring effect of the buckling of the sleeve provides a. While tightening the pinion nut, the crush sleeve compresses to allow the bearings to preload slightly
Too much bearing preload will quickly overheat and cause bearing failure when driven, and. Beginner's guide to differential repair ( how differentials work ) in this video i'm going to go over the basics of automotive differentials.
