If you enjoy mechanical repair, shaft rebuilding, and workshop. Finally got the thing done for all you people who like the jeep restoration videos. How to make a new one on a lathe when the drive shaft slip yoke breaks #making #slipyoke #breakstomake #recoveringeverythings #driveshaft
Repair Guides
Needing a project, i decided to polish it up and install it into the car
Things went smoothly until i discovered the slip yoke on my steel driveshaft wouldn't mate up with the aluminum driveshaft.
Start with a detailed inspection to identify wear and damage I picked up a used bop th350 that was working fine The original is probably in need of rebuild anyway Well since i dropped the d30 far down enough to stick in my new coils, i did not disconnect the front driveshaft from the yoke.in turn the slip yoke pulled apart
So my question is, how do you get. Learn how to create a new drive shaft slip yoke on a lathe following this diy repair guide The presence of rust on a driveshaft slip yoke is a recipe for trouble Here's how to get rid of it the proper way and how to store it the best way
Remove and refit tailshaft ( driveshaft ) universal joint and reseal the plug that seals the yoke splines
Performed on a 2002 gmc sierra. Separate the driveshaft slip yoke (4841) from the splined stub shaft on the driveshaft, and remove the driveshaft slip yoke boot Inspect the driveshaft slip yoke boot for damage and replace if. This boot will fit any tom wood's brand drive shaft with xb slip yoke
Comes with two replacement steel bands and two nylon zip ties I recorded this video alongside my axle restoration, but didn't have time to edit the video
