Now remove the cover from the power unit, once this is done you will see a. How to wire/fit an aftermarket electric antenna and how to fit a replacement mast and rope If you desire to not have your power unit run when you turn the radio on simply unplug the harness to the power unit, this varies as to each unit as to.
4K UHD custom built hot rod yellow chrom... | Stock Video | Pond5
Swap and convert from a broken power antenna to a stationary antenna in minutes with our patented conversion kit.
Before installing your new mast, compare the old mast with the new one
They need to be identical in every way If they are different, you may have an after market. Remove the power unit that is in your car, keeping track how in general the unit is mounted so you have an idea how the new one is to fit The unit is held in by the outside trim nut, where the mast comes out.
Here is a basic guide on how to replace your broken or bent power antenna mast This video shows the proper steps for all power antennas that have a toothed nylon cable. Once the power antenna was mounted, i pulled the three wires (gray, green and white) into the cabin and pushed in the rubber grommet Passenger kick panel and the lower hush panels will need to be.
Now we can carefully just pull the top mast through the antenna mast and right out the bottom
There's a rubber seal boot (nipple faces down) and felt. You can replace a power antenna with a regular antenna in two ways The first is to totally remove the power antenna system and connect a standard antenna The second is to remove the automatic.
Connect the the harness and the antenna and reconnect the battery and fire it up If all went well your antenna mast should raise when the stereo is on and retract. Introduction fix a stuck power antenna by replacing a burned out motor or bad cable/mast You can do both in about two hours, and you'll avoid.
You can save a significant amount of money if you can hear the antenna motor running when the car's radio is turned on and off but the mast.
