Then slide the assembly down towards the bottom of the seat frame and clip the bottom of the. The warranty covered the full cost of the repair but the cost of the parts was around. To repair your car’s lumbar support mechanism and potentially save over $500 compared to dealership repairs, you can follow these steps
Lumbar Control Seats for 2021 GMC Yukon XL | GM Parts Center
Start by pushing the seat forward and leaning it forward.
Wis instructs you to take the seat out, and basically tear the thing apart.
This is to install the hard felt white backing along with the bladder Yes i normally am by the book, but in this case, it. The only way to replace defective bladders is by removing the leather from the seat backrest ( i found it relatively easy to do ones the seats are out of the car). Quick demo of how to quickly and easily repair your cars lumbar support mechanism and save $500++ over dealership repairs.
I had the lower lumbar support clips already pushed out of the seat frame (again the white push in clips) so now you lift the lumbar support from the bottom and let it pivot at the top to about 90. The modules can be swapped from the driver to passenger side. It looks like it's not supported very well, so it wouldn't surprise me if this is fairly common I hate throwing things away and buying another part, so i.
In 2019 i had the lumbar support repaired in my 2015 under the gmepp warranty
It was leaking down just like yours is The warranty covered the full cost of the repair but the cost of the parts was around $300. Then slide the assembly down towards the bottom of the seat frame and clip the bottom of. Start by pushing the seat forward and leaning it.
Yes i normally am by the book, but in this case,. I had the lower lumbar support clips already pushed out of the seat frame (again the white push in clips) so now you lift the lumbar support from the bottom and let it pivot at the top to. The modules can be swapped from the driver to passenger. I hate throwing things away and buying another part, so i used some jb weld to reattach it.
