My vehicle only has 20k miles It's the large pulley and it. It's a recon no crazy off roading.
Jeep Wrangler Harmonic Balancers & Dampers | CARiD
This just happened today after i heard some extra metal noise
Turns out the harmonic balancer came out of the crankshaft pulley
I was able to remove it to. Review the symptoms associated with the jeep harmonic balancer problem Discover some of the setbacks mechanics often run into when performing this jeep repair. Diagnose a wobbling or noisy harmonic balancer on your pentastar v6 and learn how to choose a quality used replacement before it causes serious engine damage.
A slight wobble in the harmonic balancer (crank pulley) might appear normal, but it's important to investigate further Visually inspect the belt while the. Make sure your harmonic balancer doesnt have a groove from the seal or it will leak oil Morris 4x4 sells them new for about $55 so i just replaced it
If my engine was out and the crank can.
For many vehicles, the harmonic. There is a layer of rubber between the outer pulley ring and the inner portion of the balancer When the rubber fails due to age or exposure, the outer ring becomes misalligned If your harmonic balancer sheared off shortly after replacement, it's likely due to a defective part rather than improper installation
The crankshaft pulley is part of the harmonic balancer Inspect the rubber sandwiched between the outer weight and the crankshaft mounting hub. When installing the new balancer, ensure it's correctly aligned with the crank snout An impact wrench might be helpful for removing the crank bolt
Consider replacing the seal while you.
Lower most pulley, front of engine, attached to crankshaft, runs all other pulleys
